Angry Birds Balloon Wall Decor

Gridz Balloon wall Theme Angry Bird

Materials:

4 - box of Gridz with 15 squares each box (we will use 54 squares)

2 bases and 2 poles to hold the frame.

1 -Eletric balloon inflatior

100 - 11" Red latex balloon (need 81)

200 - 5" Red latex balloon (need 150)

12 - 11" Gray latex balloon (need 8)

20 - 5" Gray latex balloon (need 14)

22 - 11" White latex balloon (need 17)

30 - 5" White latex balloon (need 24)

130 - 11" Ligth Blue latex balloon (need 117)

PS: Buy extra balloons if you do not have much experience.

If you want to order the balloons with us, you can buy Kit Angry Bird Balloons at http://usartballoons.com/learn/kit-angry-bird-balloons

Assembly together 54 squares pieces of Gridz as show at the picture below:

Visit our link to see how to assembly the Wall Plastic Gridz at http://usartballoons.com/learn/portal-wall-plastic-grid-assembly

Underinflate the balloons to 7.5” so that they fit in the grid squares. Tie the balloon off so that it is flexible and does not burst while being installed. A knot tied closer to the lip of the balloon will make a more flexible balloon. To install, place the balloons in the center of the grid with the neck of the balloon facing down away from the outer perimeter. The necks should not be visible, in order to give the work a clean finish. On the last row of the grid, the balloon tips should be placed on the inner edge of the frame.

Before start the project inflate just one balloon to size 7,5" according instructions to check if your balloon sizer it is correct.

To fill the spaces between the large balloons make a duplet of two 5 in. latex balloon inflated to size 3" or 3,5" and insert it before you put the large balloon.

It will give to you a 3D effect and add life to your wall.

Observe in the picture we add some duplets on white, red and gray area only.

Drow the Angry Bird face on a glue paper or EVA foam according your ability and glue on your balloon wall to finish your project.